All public logs
From EFlightWiki
Combined display of all available logs of EFlightWiki.
You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).- 14:40, 13 May 2011 DaveE (Talk | contribs) moved Talk:E-flite Blade mCPX to Talk:Blade mCPX (This helicopter has never been marketed under the E-flite brand.)
- 14:40, 13 May 2011 DaveE (Talk | contribs) moved E-flite Blade mCPX to Blade mCPX (This helicopter has never been marketed under the E-flite brand.)
- 14:02, 19 April 2011 DaveE (Talk | contribs) uploaded a new version of "File:HK500GT slotted frame.jpg" (HK-500GT frame modification: One of four slots lengthened by 0.5mm to allow the boom holder to be slid forward to provide proper tail mesh. It is also necessary to slot the screw holes.)
- 13:47, 19 April 2011 DaveE (Talk | contribs) uploaded "File:HK500GT slotted frame.jpg" (holes for screws slotted and length of slots for bosses lengethend by 0.5mm. Boom holder slid forward approx 0.25mm to achieve proper tail gear mesh.)
- 13:17, 19 April 2011 DaveE (Talk | contribs) uploaded "File:HK500GT tail mesh ok.jpg" (Tail gear mesh properly set after slotting frame. It is necessary to assemble with the main gear omitted (the hub should be on the shaft, without the gear itself) to allow the mesh to be checked visually.)
- 10:59, 30 March 2011 DaveE (Talk | contribs) uploaded "File:HK500GT tail mesh issue.jpg" (Inadequate mesh between tail autorotation gear and pulley shaft gear on GiantCod-supplied HK-500GT. Gears interfere by less than 1mm - compare depth of teeth of main gear above.)
- 18:08, 10 March 2011 DaveE (Talk | contribs) uploaded a new version of "File:Bec.jpg" (Hobbywing 3A switched-mode BEC)
- 18:07, 10 March 2011 DaveE (Talk | contribs) uploaded "File:Bec.jpg" (Hobbywing 3A switched-mode BEC)
- 17:14, 10 March 2011 DaveE (Talk | contribs) uploaded "File:Ferrite ring.jpg"
- 19:43, 11 January 2011 DaveE (Talk | contribs) uploaded "File:HK500GT main gear.jpg" (The HK500GT main gear can sometimes be out of alignment. If this is too bad, replacement may be needed.)
- 19:41, 11 January 2011 DaveE (Talk | contribs) uploaded "File:HK500GT tail grip.jpg" (Tail grip showing square corners that cause stress concentrations.)
- 14:36, 22 December 2010 DaveE (Talk | contribs) moved PiccoZ to PicooZ (Incorrect name! See http://www.silverlit.com/)
- 19:59, 31 May 2010 DaveE (Talk | contribs) uploaded "File:AR6400.jpg" (Connections on Spektrum AR6400)
- 14:12, 1 March 2010 DaveE (Talk | contribs) uploaded a new version of "File:Electronics schematic Rx pack.jpg"
- 14:11, 1 March 2010 DaveE (Talk | contribs) uploaded a new version of "File:Electronics schematic UBEC.jpg"
- 13:56, 1 March 2010 DaveE (Talk | contribs) uploaded a new version of "File:Electronics schematic.jpg"
- 13:51, 1 March 2010 DaveE (Talk | contribs) uploaded "File:Electronics schematic UBEC.jpg" (Schematic for electronics where a seperate UBEC is used and the integrated BEC in the ESC is disabled.)
- 13:50, 1 March 2010 DaveE (Talk | contribs) uploaded "File:Electronics schematic Rx pack.jpg" (Schematic of electronics where an Rx pack is used instead of the BEC integrated in the ESC.)
- 12:49, 1 March 2010 DaveE (Talk | contribs) uploaded "File:Electronics schematic.jpg" (Schematic showing the connections between battery, ESC, receiver, servos, and motor, when a BEC integrated into the ESC is used.)
- 16:24, 11 February 2010 DaveE (Talk | contribs) uploaded "File:Russian Air Force Kamov Ka-50.jpg" (Full-scale Russian Ka-50 helicopter. Image taken from Wikipedia.org. The upper swash plate is easily visible between the two sets of rotors, as is the differential pix mixer at the very top of the rotor head.)
- 10:31, 11 February 2010 DaveE (Talk | contribs) uploaded "File:BladeMSR.jpg" (E-Flite Blade MSR)
- 14:17, 23 January 2010 DaveE (Talk | contribs) moved Honey Bee CP2 to Esky Honey Bee CP2 (match other Honey Bee page titles)
- 22:04, 29 July 2009 DaveE (Talk | contribs) uploaded "File:MultiplexFoxPylon2.jpg" (Multiplex Fox R/C electric conversion with motor mounted on pylon)